small port engine

[jondee86]

You will need to make a hole for the blue top IAT, and you will need a
smallport fuel rail. Everything else is pretty much the same between the
two engines. You will be swapping over the sensor block at the back of
the head, and using the RWD water pump and water lines. Use the RWD
alternator and brackets. Use the RWD crank pulley. That way, those three
pulleys will all line up. Small port uses a PWM idle-up valve, but you
should be OK with the blue top on/off idle-up valve.

Small port fueling will be a bit a bit different from the blue top, so you
will need a piggyback, adjustable FPR and/or the small port injectors to
get a bit of a tune going

Cheers... jondee86