T3 FULL coil over system (front and rear), who is using them

[drako323]

I have them on a stock chassis (which means both un-reinforced and heavy weight compared to a race car) with 250lbs springs. Full greek road use (big potholes...) on sports tyres (not too much grip there). In general I am satisfied, but I can say the following for the rear:

- There is an issue with the clearance from the upper spring hat to the chassis. I grinded at least 2mm but still it would touch.

- The adjustment on the rear agx's is not really doing much, compared to the front. That is probably because it doesn't affect the piston, but more likely a valve system outside the shaft chamber.

- There is noise from the spring since there aren't any helper springs to keep it in place when on rebound. And this will probably get worse with harder springs.

Other than those issues I'm satisfied for road use and the only things I would do is strengthen the rear mounting points (top and bottom just to be psychologically ok) and grind a bit more......(I take it for a fact you have an adjustable panhard rod)