Surreptitious.....

[oldeskewltoy]

Well, on to the clutch hydraulics.




Hmmmm, that is undoubtedly a new hydraulic line... note it goes behind the brake master cylinder reservior, and tucks under the body seam, bends, and goes straight down to the original hydraulic line - now too short and having the wrong end. Oh... the actual location is behind the head, it is somewhat of an illusion that it appears closer to the header then it is.



Wrong end? How could it be the wrong end????


Here is the original clutch line



The end on the right would thread into the slave... BUT



As this shot plainly shows... the header is now in the way... so instead of a straight line, the slave end will now be fitted with a banjo bolt and proper fitting to make a tight, and immediate 90 degree bend, and snake along the starter and up to the new line location seen above.


The new line is being made by Techna-Fit, it'll be 3 1/2" longer then the standard line, the fitting seen on the left in the line photo above will be retained, while a banjo end will be mounted on the other end to keep it away from the exhaust