Tuned 4AGE results

[mcm95403]

Hi Guys,
I'm looking at buying a set of Catcams for my new engine. I have an 86 MR2 (sorry, no AE86) with a blacktop 6 speed conversion. I'm doing a complete wiring harness swap so that I can run all of the 91 high compression parts - computer, knock sensor, big injectors (215cc I think), etc. I also have or will be using:

Complete small port bottom end
blacktop rods
approx 11:1 compression (TRD .8 mm HG and .020/.5mm shave on the head, and 10.3 pistons)
Total Seal rings
Custom "mid port" head - this is a big port head with the intake ports slightly reduced in size. I will also be port matching a small port intake to fit. Doing this on a mill so that I can take out material about 3" into the intake port. O/S valves, will do some porting in the bowls and also on the exhaust side of the head, running toda springs
TRD header (will later be replaced with a BT header and custom pipe) with mandrel bent 2 1/4" stainless exhaust
light flywheel (4.7kg)
adjustable cam gears
low drag water pump
under drive pulleys for alt and h2o pump, light crank pulley
6 speed with 4.529 gears and the wonderful close ratios - can you tell I LOVE the 6 speed!?!?!?

My problem is, I live in California so I have a problem passing smog testing if I change too much. I'm wondering if anyone has video with sound of the Catcams7105137 cams. I think those would be best suited to the rest of the engine. I'd like to hear the idle quality.

Full info on my car on my website as listed in my siggy.

Also, wondering if you guys are running on roller type dynos.

Here are a couple of videos of mine on the dyno I'm using:

http://www.youtube.com/watch?v=bSxJCrPRcKo

http://www.youtube.com/watch?v=qyLY1wPqt...re=related