Question about raising compression?

Threaded Mode | Linear Mode

Question about raising compression?

01-29-2005, 11:05 PM

Post: #15

jamiemirror Offline

Posting Freak

Posts: 1,639
Joined: Jan 2005
Reputation: 0

I prefer to cut the stock wheel and use inner and outer parts with additional O-plate to insure adjustability. That way machining will be required for cutting and for the O-plate only. Will provide pictures when I'm done.

« Next Oldest | Next Newest »

Messages In This Thread

Question about raising compression? - Mulisha - 01-26-2005, 11:53 PM

[] - Aico - 01-27-2005, 01:43 AM

[] - Mulisha - 01-27-2005, 03:06 AM

[] - s.bjelke - 01-27-2005, 04:57 AM

[] - jamiemirror - 01-27-2005, 10:38 AM

[] - Mulisha - 01-27-2005, 07:18 PM

[] - Aico - 01-27-2005, 07:46 PM

[] - jamiemirror - 01-27-2005, 08:10 PM

[] - Mulisha - 01-28-2005, 02:04 AM

[] - PetzK - 01-28-2005, 09:13 AM

[] - jamiemirror - 01-28-2005, 09:56 AM

[] - Mulisha - 01-29-2005, 04:18 AM

[] - jamiemirror - 01-29-2005, 03:19 PM

[] - Mulisha - 01-29-2005, 06:07 PM

[] - jamiemirror - 01-29-2005 11:05 PM

[] - Ivan141 - 01-30-2005, 11:37 AM

[] - jamiemirror - 01-30-2005, 12:08 PM

Possibly Related Threads...
Thread		Author	Replies	Views	Last Post
	82mm Stock compression Pistons	apardal	4	4,511	11-24-2021 04:26 PM Last Post: apardal
	working out compression ratios	kazi	2	4,938	07-16-2019 08:22 PM Last Post: oldeskewltoy
	Raising the rev limit on stock ECU	fax0815	2	12,727	08-31-2015 02:04 PM Last Post: gon
	What is cranking compression on 10-1 4AGE?	oldeskewltoy	2	5,907	03-24-2015 10:18 AM Last Post: ditn
	What fuel are you high compression guys running?	4000GT	18	20,727	09-04-2011 07:11 PM Last Post: IBMFD3S

User(s) browsing this thread: 1 Guest(s)