VEMS discussion

[phatBob]

Aside from the surface mount technology, modern electrical components, water tight casing, Econoseal connectors (same as Motec use), built-in wideband, EGT and knock sensor hardware there is not much difference between the VEMSv3.3 and MS, saying that theres not much difference between the MS and a range of other ECUs, they have reached a level where so many are functionaly similar because they are functions that you would need on an ECU.

I do take exception to the comments about the support not being good - HOW DO YOU KNOW? I have never been approached by anyone here for a technical question by anyone here apart from Skassa.

Skassa (Denmark) appeared out of nowhere and bought a VEMS for his 20V, I gave him all the maps and information that I could and supported his installation as best as I could, he used my user guide:
http://www.vems.hu/wiki/index.php?page=M...FUserGuide

Looked at the information that I had collated on the 20V installation I did on Simon86's car:
http://www.vems.hu/wiki/index.php?page=M...otaFitting

And the information that collated on the other Toyota aspects:
http://www.vems.hu/wiki/index.php?page=V...t%2FToyota

And was up and running in very little time.

Perhaps he could tell us what he thinks about the support.

Also, its a little thing to consider but VEMS has been designed and manufactured in the EU, when you buy one from the HQ in Hungary you're not seeing your money disappear off to the otherside of the world, the money is in the EU and its employing people.