AEU86 : EU AE86 Community - AE86 - AE86 : Technical v - Pistons, Clearances, Compression Ratios and Fuel

Pistons, Clearances, Compression Ratios and Fuel
06-26-2007, 03:28 PM
Post: #4
apardal Offline
Senior Member
****
 		Posts: 512
Joined: Jan 2005
Reputation: 0
 
Lipinhu, you should read the post again. My calculations are for 1mm head gasket. Thinner head gasket would raise the compression even more. My question is between 1 and 1.6mm.

NoHachi - NoIdea!

Engine wasn't running lean. Was indeed running higher RPM. Might have ran with the ignition timing too advanced a long time ago that could have damaged the pistons. It wasn't water temperature. Oil temperature, I don't know.

Anyway... what I really want to know is what compression you guys think I should run? And with which gasoline?

Best regards
Find all posts by this user


Messages In This Thread
[] - Lipinhu - 06-26-2007, 12:14 PM
[] - NoHachi - 06-26-2007, 01:23 PM
[] - apardal - 06-26-2007 03:28 PM
[] - NoHachi - 06-26-2007, 04:10 PM
[] - Rasteirinho - 06-26-2007, 05:35 PM
[] - Ivan141 - 06-26-2007, 07:32 PM
[] - Denmark - 06-26-2007, 11:36 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  82mm Stock compression Pistons apardal 4 4,663 11-24-2021 04:26 PM
Last Post: apardal
  working out compression ratios kazi 2 5,066 07-16-2019 08:22 PM
Last Post: oldeskewltoy
  Trunk and fuel door cable pack 2 8,897 04-23-2018 11:01 PM
Last Post: pack
  Small Port 10.3 Pistons Alex170984 1 5,482 10-25-2016 09:18 PM
Last Post: oldeskewltoy
  What is cranking compression on 10-1 4AGE? oldeskewltoy 2 6,010 03-24-2015 10:18 AM
Last Post: ditn

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication