|
4AGE Big port head failure
|
|
01-21-2026, 06:26 PM
(This post was last modified: 01-21-2026 06:27 PM by oldeskewltoy.)
Post: #3
|
|||
|
|||
|
RE: 4AGE Big port head failure
Bent cams are very rare. There are ways of checking - easiest is to bolt the camshaft into a bare head and see if they rotate smoothly. Other is to use "V" block to check for any wobble during rotation.
Most likely bad luck. Did the head and cam run before the rebuild? Or was the head and cams a used part you picked up to build your engine? Dan - You can |  .... OR you can ask for help!!!OST Porting service - http://hachiroku.net/forums/showthread.php?t=19991 |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
4AGE Big port head failure - Blaze0010 - 01-21-2026, 02:00 PM
RE: 4AGE Big port head failure - The Doctor - 01-21-2026, 04:09 PM
RE: 4AGE Big port head failure - oldeskewltoy - 01-21-2026 06:26 PM
RE: 4AGE Big port head failure - totta Crolla - 01-23-2026, 03:35 PM
|
| Possibly Related Threads... | |||||
| Thread | Author | Replies | Views | Last Post | |
| 4AGE cylinder head plug removal | Ivan141 | 5 | 4,867 |
09-30-2023 09:47 PM Last Post: Ivan141 |
|
| Big wheel problems | gh0st | 16 | 14,210 |
11-15-2021 10:51 PM Last Post: gh0st |
|
| 20v mains & big end bearing | izanagi | 9 | 13,622 |
12-26-2016 12:42 PM Last Post: pack |
|
| Small Port Swap | Alex170984 | 1 | 5,435 |
11-21-2016 01:46 PM Last Post: Alex170984 |
|
| Small Port 10.3 Pistons | Alex170984 | 1 | 5,645 |
10-25-2016 09:18 PM Last Post: oldeskewltoy |
|
User(s) browsing this thread: 1 Guest(s)