wiring harness, gaskets,etc 4agze

[JDMjonSR5]

I have my gze motor and I need a writing harness that is already to just go into the car considering I have an SR5 and not a gts that I can use to splice into. Anyone have one for sale? I know one guy did on here but Idk if he still does.

Next are I need to know if the head, valve, rear main seal gasket, etc are the same as the 4age or not? While the motor is out I am going to replace all the gaskets and seals I can so I don't have to worry about them as much. If they aren't the same where do I go to get them? Do I have to order them from japan?

What did anyone else use for the intercooler piping? I have a top mount inter cool that has been converted to a front mount(done by a pro) I just need the piping.

I found a forum with details on the swap but his starter is on the drivers side, so do I need to get a gts starter so it has the heat shield? I was told that you need a t50 tranny or at least the bell housing. Is this because the slave cylinder/ throw out bearing gets in the way of the exhaust?

I think that's all my questions for now and any help would be great. I need to get me 86 driving asap do to my landlord getting mad that is just sitting in my drive way, plus more importantly I just want to be able to drive it again.

Thanks[/i]