Clutch Slip - Adjustment

[DMC]

Thanks for the replies!

(04-24-2025 10:55 AM)Ivan141 Wrote:  You need to check for oil leaks around the bellhousing.. sounds like a leaking main crankseal to me.

I had a look but I couldn't see any leaks. I did have a leaky sump last year, but that was sorted and maybe done 1000 miles after that with no issues.

(04-24-2025 12:35 PM)Dave W Wrote:  Not likely, but the rubber hose to the slave cylinder, if it is old and hard could be restricting return flow to the slave cylinder. Do you have a return spring on the clutch arm. Is the slave cylinder push rod preloading the clutch arm. Or is the M/C rod not returning far enough in the master cylinder to release pressure. If none of these check out, you are probably going to have to pull the trans and inspect the clutch.

I'll try and get a look into those suggestions tomorrow.