American Rally 86 UPDATE

[dazed_driver]

Thanks! I forgot to make a general overview of whats going on, so here's one!


Engine:

Port blended small port head with over sized intake and exhaust valves
Web Racing cams, Grind 110- 256 duration at .050 lift. The lift is a little over 10mm.
Toda valve springs
Shimless buckets
Wiesco forged aluminium pistons, 12:1 compression
Balanced internals
No idea about the flywheel or clutch yet. All I know is I want a 4 puck cerametallic disc.
Fully deburred block
GSX/R 600 throttle bodies
No idea about exhaust yet. I think I may just pull a Group A and bore out the stock manifold and the down pipe... allthough to save wieght, I might just dish out some money for a nice header

Transmission:

For now, just the stock T50, I'll see how that does and/if/or I break it, I'll get a Ford Sierra's Type 9 with a close ratio gear set

Rear Axle:

Celica Supra axle with a 5.3 final drive and LSD

Brakes:

Eventually will be
Dual master cylinder set up with a hydraulic handbrake.
Wilwood powerlite calipers in the front
Wilwood 2 pot dynalites in the rear
10x.810in (254x20.57mm) discs up from, slotted and vented
Stock supra rear discs, 10x.38in (254x9.65mm) flat unless I can find slotted and solid rotor

Body and chassis:

Seam welded from strut towers to turrets
Rear turret kit
Full roll cage
Lowered seat mounting postions

Suspension:

JVAB 40mm Bilstein based coil overs
Reinforced lower control arms
Equal length extended 4 links (aiming for around 30 inch (76.2 cm) links without the length of the rod ends
Cage reinforced front strut towers

Fuel and Ignition:

Duel electric fuel pumps
Fuel Safe 15 gal fuel cell, enduro
Autronic or Haltec ECU
Some form of CD ignition, maybe MSD
Push button ignition
Optima red top battery
Master cut off switch

Interior:

Sparco Corsa seats
Custom carbon fiber dash
Custom gauge set
Custom CF pedal kit (heel toe & LFB better!)
Undecieded racing wheel w/ two buttons (either stock or added buttons) for killswitch and horn



That should be most of it, I'm sure I'll remember some more later. Also, I'll try to get the newest version of the cage uploaded (I've designed it in 3d)

And, I'll get the pictures taken of my 4 link mock up and the work I did today on the floor.