The A6 Celica/Carina topic

[Motax]

They do fit on a TA60, altho the bottom coil on the stock springs is a bit smaller. Seeing as the AA63 has independant rear suspension, my guess is that they don't fit.

Also, some more info about what will fit, and what not, on the TA60.

TA60 steeringarms do NOT share the same boltwidth with the AE86,
So, if you swap suspension, make sure it's complete with steeringarms

S13 camberplates will fit, with slight slotting of the holes (+/- 1mm)

TA60 spindles will fit AE86 struts, but will leave the cotterpin hole half covered. I used a smaller cotterpin to solve this problem.

TA60 brakebrackets (the ones that bolt onto the strut) do NOT bolt onto the AE86 struts. I used a combination of the AE86 brackets and TA60 caliper, combined with a few spacers and longer bolts in order to use the TA60 brakes.

Rear AE86 springs will fit, but the lower coil on the TA60 spring is a bit smaller. Can be solved with a blowtorch, or just leave it as is and hope for the best (i used an extra rubber from the top to get it to seat properly).

Rear shocks is just about the same as any other toyota, pretty straight forward, eye mount on the bottom. Top goes through the floor.