CJ's AE86 project
|
10-24-2008, 09:56 AM
Post: #52
|
|||
|
|||
cj Wrote:You are totally correct. I have read that some QSRs have even less angle than stock. But in my case i have additionally custom made 2 more teeths as well as shaved some part of the inner tie rods. This is how i expect to achieve a little more steering angle than stock. Yeah, the first gen QSR had LESS teeth cut than stock. Taka Aono was one of the ones to find that out from what I remember. 2nd gen had the correct amount/matched stock. (I have the one and only 2nd gen with extra teeth cut for stupid extra angle - which will never be usuable as the steering knuckles/tie rods will go over center - I think I can get an extra 30+mm of rack travel ) 3rd gen & up supposedly already have an extra tooth or two already so as to take advantage of aftermarket parts that would give more angle (either tie rods or a pair 5mm spacers). Andrew |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
CJ's AE86 project - cj - 09-29-2006, 11:57 AM
[] - Eircamae86 - 09-29-2006, 12:17 PM
[] - mr monster - 09-29-2006, 12:24 PM
[] - Ivan Petrov - 09-30-2006, 06:26 PM
[] - TOYCOOL GARAGE - 05-22-2007, 09:37 AM
20v installed - cj - 11-01-2007, 02:35 PM
[] - The Doctor - 11-12-2007, 01:43 PM
[] - projectrollas - 05-21-2008, 07:08 PM
[] - SekiguchiUeno - 06-25-2008, 08:31 PM
[] - assassin10000 - 10-23-2008, 10:12 PM
[] - assassin10000 - 10-24-2008 09:56 AM
|
User(s) browsing this thread: 1 Guest(s)