Steering shaft issue

[Ryo]

Yes i figured that the stopper bearing on the bottom the one with 2 screws is a bit tricky as the screws when you over tighten them can spin in the plastic casing which holds the bearing there is torque defined for them 13nm trouble is i have 3 stoppers at home but on one the bolts are already turning in the plastic on second i tightened one only to 10nm than it turns the third i have not tested. This is as well another trouble as i would like them repaired as spare but must figure out how to fix the nuts in the plastic i might try use one stopper remove the existing nuts from plastic and replace them with 6 side regular nuts. The stopper is a discontinued part so i will be not able to get a new one. For fixation of the main shaft i found loctite HY4090 the gap i need to fill in that have been those nylon bushes is between the shafts is 2.5-3mm in deepest area the HY4090 can handle vibrations and it is used to gluing parts up to 5mm so it should work. There are other loctite glues with hybrid technology that might work as well i need to study them more.