Aftermarket Cams, IDLE issue.

[kool mints]

Hey Guys,

Installed my Camtech 266 degrees 8.75mm lifts Cams today, can feel the extra punch around mid to top end and also revs nicely to redline as in before it would chocked up top end.

Also, adjusted the TPS screw next to the TPS sensor to over come the car from shutting down after braking. All good.

NOW:

Only problem i have now is that car would not IDLE nicely, it would be stable for less than a min and would just fluctuated and then the car would shut off on its own. By the looks of it, its properly ranning lean, correct me if i'm wrong?

What would i need to do to over come this IDLE problem? Adjust the idle controller?

Its currently IDLING on 1200rpm

Bear in mind, i'm ranning stock JDM ECU on JDM 4age 16v blue top.

Any tips, advice would be much appreciated guys.

Thanks in advance.

Cheers