Carina drivers! - Coilovers for a TA60/62

[nyberrg]

(05-24-2017 10:28 AM)domi007 Wrote:  Hi,

I have an TA60 Celica, it is the same platform as the Carina. I know the following:

FRONT
S13 camber plates work with minor adjustments of the bolts. MA6x Supra camber plates don't work.

For the bottom you should get a rolling center adjuster. The only ones I know of are manufactured by T3. AE86 ones DON'T work.
I think the easiest is to get 2 sleeves from https://www.rallydesign.co.uk , cut and weld your strut, get short stroke shocks, here is a complete guide
http://club4ag.com/faq_and_tech_pages/Sh...ersion.htm

REAR
You can use AE86 coilovers, they bolt up if I remember correctly. I personally decided to go on the cheap way for the rear and just got a pair of yellow Koni shocks (AE86 ones) and stiffer springs (Nissan 350Z early models work fine, and they are 6.1 kg/mm, got them for like 30 euros on ebay for a pair).

MA60 roll center adjusters fit my carina. Currently run those. I was thinking of ordering custom BC Racing ae86 coils with s13 camber plates and then get ae86 knuckles to bolt them in the bottom.

I dont know if the knuckles will fit yet though. There may be some spare ones in my garage but i got some sudden engine issues to sort out first

Skickat från min ONEPLUS A3003 via Tapatalk