problem again , about leaking half shaft bearing

[filh]

Thanks Jondee, the oil seal is new and I tried 2. Now I have applied sealant between the oil seal and housing.But Had no time to test .
Next rally is planned for March 29 ....

And I also applied a trick a friend gave me about the oil seal spring:
Removing the spring , you can open it , as there is a small "screw axis ".
Just find it and unsrcew one side of the spring . Just cut , let's say 5mm to 10mm. Screw it again and put it in place . The lip will be more tight and a better sealing can be obtained .
Done , but not tested .

Just fitted my FC Mazda RX7 calipers , and all must be tested....
REgards
Phil