Machining Pistons to run 20v head... And FCR's on a 20v?
09-11-2013, 07:17 PM
Post: #1
Machining Pistons to run 20v head... And FCR's on a 20v?
Anyone up on this?

I might be running a 20v head on my 16v, is pocketing a high comp 16v forged piston to take the 5th valve something that can be done?

Also, anyone ran FCR's on a 20v head? This head has no VVti to worry about, so my current FCR's should theoretically go on with a new inlet manifold and a Dizzy relocation kit.. Right?

Ta!

Driftworks - JSPFab.com - DangerStyle - NightSpirit
Find all posts by this user


Messages In This Thread
Machining Pistons to run 20v head... And FCR's on a 20v? - PazzaAE86 - 09-11-2013 07:17 PM
[] - jondee86 - 09-15-2013, 01:08 AM

Possibly Related Threads...
Thread Author Replies Views Last Post
  82mm Stock compression Pistons apardal 4 2,175 11-24-2021 04:26 PM
Last Post: apardal
  Where to run the factory antenna cable andyling 2 3,129 09-30-2020 12:31 PM
Last Post: andyling
  Small Port 10.3 Pistons Alex170984 1 4,048 10-25-2016 09:18 PM
Last Post: oldeskewltoy
  How to install 20V ITB on 16V head Mr.komp 7 10,798 12-28-2015 05:35 PM
Last Post: pack
  20v block with 16v head and internals possible? ditn 3 6,450 08-12-2014 09:19 PM
Last Post: ditn

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication