Driveshaft question
02-11-2015, 04:40 PM
Post: #1
Driveshaft question
Hello everybody,

I took the 2 piece drive shaft apart that runs from the tranny to the rear axle. Do I have to get it balanced again or can I just put them back together? I dont know in which position they were connected before.

Thx!
Find all posts by this user
02-11-2015, 04:56 PM
Post: #2
Driveshaft question
As far as i'm aware you can just put them together. Only PAY ATTENTION to the universal joints, they should be in phase. Or in other words swiveling the same, not that one is rotated 90deg along the centerline of the shaft.

AE86 Levin
Find all posts by this user
02-12-2015, 02:54 AM
Post: #3
Driveshaft question
I belive they are ballanced induvidually and can be assembled in any way, but phasing is important...

1979 Toyota Corolla KE35
1983 Toyota Corolla AE86
1985 Toyota Corolla AE86
Find all posts by this user
02-12-2015, 09:43 AM
Post: #4
Driveshaft question
Ok thx for the info, I'll take a picture when I put it back together and post it here.
Find all posts by this user


Possibly Related Threads...
Thread Author Replies Views Last Post
  AE86 Driveshaft too long? [SOLVED] MyCrazyGarage 12 5,015 07-28-2022 10:48 PM
Last Post: banpei
  Kaaz 1.5 way Diff - Driveshaft Compatability chrisae86 1 2,042 05-10-2021 01:02 PM
Last Post: Project D
  Driveshaft free play thanos 6 8,730 02-25-2015 02:10 AM
Last Post: thanos
  anyone produce new harness for bluetop?gts driveshaft dinkers542 8 7,626 11-25-2014 09:18 PM
Last Post: dinkers542
  driveshaft center bearing issue chenfon 8 11,524 11-30-2012 12:06 PM
Last Post: chenfon

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | AEU86 | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication